Chris Powell | Voronoi pattern cut on Shapeoko cnc router in plywood @ChrisPowellFSD | Uploaded April 2019 | Updated October 2024, 14 hours ago.
This is a test run I did on my cnc router. I plan on building a coffee table using these patterns. There’s a couple pictures of the rendering of the table top in the video. After it was finished machining, I used a chamfer bit to put a very slight chamfer on the bottom, and about a 1/2 inch one on the top. This reveals the layers of plywood. I plan on building the whole table out of birch plywood. Stay tuned for updates in the near future.
This is a test run I did on my cnc router. I plan on building a coffee table using these patterns. There’s a couple pictures of the rendering of the table top in the video. After it was finished machining, I used a chamfer bit to put a very slight chamfer on the bottom, and about a 1/2 inch one on the top. This reveals the layers of plywood. I plan on building the whole table out of birch plywood. Stay tuned for updates in the near future.