VCT transfer punch helps to line up my drill press chuck #drillPress @UDoIt2
VCT transfer punch helps to line up my drill press chuck #drillPress @UDoIt2
Uploaded April 2025 | Updated September 2026, 3 weeks ago
I'm using my VCT transfer punch in my drill press chuck to identify the center of the chuck over my mark. If you see the related video I'm using my tape measure to line it up. That worked well.

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.

#welding #plasmacutter #metalworking
VCT transfer punch helps to line up my drill press chuck #drillPressCleaning two-story gutters with a pressure washer & Sun Joe Gutter CleaningHow to clean siding on a 2 story house with a pressure washerSaving money by growing your own garden in a raised bed planterAssembly and Installation of the Draft Stopper 3.0Wood Is Good Podcast Forum with Florida WoodworkersWhy does it never work out the way you planned? #PlasmaCNCUDoit Fabricates - Truck Bed Extender for Long Loads - Ep. 1Save money by rebuilding your grill burnersHow to install a GFI outlet in basement from start to finishHow to install LEDs behind TVHow to setup the Rode PSA1 boom arm
U Do It |

VCT transfer punch helps to line up my drill press chuck #drillPress

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER