Uploaded November 2024 | Updated November 2026, 5 days ago
Finally, time for paint and varnish on the kayak! I use @totalboat TotalProtect epoxy primer inside the bulkhead areas at each end of the boat for a thick layer of protection. The rest of the boat is varnished with Gleam gloss varnish, building up about 8-10 coats on all surfaces. The best process is what’s known as “roll and tip” where you roll out the varnish for a consistent and thin layer, and then tip off all the bubbles and drips with a brush. I don’t sand between coats because you don’t have to with this varnish as long as you don’t let it dry for too long (the actual number is on the can, but from memory it’s somewhere between 6-10 hours).
Finally, time for paint and varnish on the kayak! I use @totalboat TotalProtect epoxy primer inside the bulkhead areas at each end of the boat for a thick layer of protection. The rest of the boat is varnished with Gleam gloss varnish, building up about 8-10 coats on all surfaces. The best process is what’s known as “roll and tip” where you roll out the varnish for a consistent and thin layer, and then tip off all the bubbles and drips with a brush. I don’t sand between coats because you don’t have to with this varnish as long as you don’t let it dry for too long (the actual number is on the can, but from memory it’s somewhere between 6-10 hours).










