Bens Workshop | Vaorwne 400R 50MM Milling indexable Face Shell Mill review and fitting @BensWorkshop | Uploaded August 2021 | Updated October 2024, 3 days ago.
I bought this all steel indexable face/shell mill via Amazon. It did have some problems, here is how I resolved them and testing it cutting in both aluminium and cast iron. Since filming I have also cut steel.
0:00 introduction
1:39 measuring runout
5:53 Showing how the head does not fit the arbor
7:13 fixing the arbor by lapping
14:10 Showing the result
15:00 Refitting drive dogs
17:05 measuring the finished arbor
18:10 Fitting the carbide inserts
22:03 Fitting cutting head to arbor
23:15 Measuring the depth of each tooth with a DTI
26:09 Adjusting mill head height.
27:47 Face milling aluminium
33:00 Checking the finish on aluminium
35:00 Face milling cast iron
I bought this all steel indexable face/shell mill via Amazon. It did have some problems, here is how I resolved them and testing it cutting in both aluminium and cast iron. Since filming I have also cut steel.
0:00 introduction
1:39 measuring runout
5:53 Showing how the head does not fit the arbor
7:13 fixing the arbor by lapping
14:10 Showing the result
15:00 Refitting drive dogs
17:05 measuring the finished arbor
18:10 Fitting the carbide inserts
22:03 Fitting cutting head to arbor
23:15 Measuring the depth of each tooth with a DTI
26:09 Adjusting mill head height.
27:47 Face milling aluminium
33:00 Checking the finish on aluminium
35:00 Face milling cast iron