Valve Train Complete & Rocker Shaft Tech Tip @crateengines
Valve Train Complete & Rocker Shaft Tech Tip  @crateengines
Uploaded June 2026 | Updated November 2026, 3 hours ago
The valve train on this custom build is officially complete! Here is a breakdown of the latest progress and a crucial tech tip straight from the shop:

PRW Rocker Shaft Details:

This setup uses high-quality PRW rocker shafts that require careful assembly and shimming.

The goal is to achieve about 15 to 20 thousandths of an inch of side play between the rockers.

Crucial Tip: When adjusting these, pay close attention to the oil hole on the adjuster that feeds oil up through the system.

You can only back the adjuster out about two or three threads.

Backing it out any further will expose the oil hole, which is a major mistake you want to avoid.

External Balance Update:

Because this engine uses a cast-iron crankshaft, it requires an external balance setup.

The build is currently waiting on the correct harmonic balancer to arrive.

The initial balancer received was incorrect because it lacked the required weight, so the properly weighted balancer is on the way to finish things up.

Proformance Unlimited
Melbourne, FL
321-430-2465
proformanceunlimited.com
Valve Train Complete & Rocker Shaft Tech TipLS Drift Car Engine #crateengines #custombuilt #restomod #racing #driftcarPiston C-Clip InstallationProformance Unlimited 625HP 73L Ford Godzilla Crate Engine Dyno TestBehind the Scenes at the Shop! πŸ”§Chevy LS3 427CI DynoInnoV8 Stack Injected 7.3L Godzilla Performance Engine Dyno TestLS3 430CI Test And TuneAirboat LS 427 3.0 Whipple SuperchargedEngine Building 101: The Crankshaft Thrust Debate πŸ”§524HP Small Block Ford DYNO PULL! 🏁 408CI SBF #shortsDescription:πŸ”₯ Shop Update from Doug at Performance Unlimited! πŸ”₯
Proformance Unlimited |

Valve Train Complete & Rocker Shaft Tech Tip

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER