Uploaded May 2024 | Updated November 2026, 8 hours ago
We wanted to have a go at making our own moulds for injection moulding, so we thought we'd test this by trying to make some simple book page holders. We used our beasty little Wazer water jet cutter to make the middle plate and then bolted this up in between two of our sandwich mould plates. Then once injected, all we had to do was drill the thumb hole, add a little round over and we were done! 📖
#trashtotreasure #waterjetcutting #injectionmoulding #plasticrecycling
We wanted to have a go at making our own moulds for injection moulding, so we thought we'd test this by trying to make some simple book page holders. We used our beasty little Wazer water jet cutter to make the middle plate and then bolted this up in between two of our sandwich mould plates. Then once injected, all we had to do was drill the thumb hole, add a little round over and we were done! 📖
#trashtotreasure #waterjetcutting #injectionmoulding #plasticrecycling










