Uploaded June 2022 | Updated November 2026, 3 days ago
In this Quick Tip I show how to use CA glue with a straight edge to make your table saw into a jointer. If you're like me and don't have a jointer, this can be a very useful technique to get a flat straight edge on your boards.
It is possible to do this with double sided tape, but it works better with cyanoacrylate glue (CA glue).
You can get Starbond CA glue on their website here: (affiliate link)
starbond.com/?rfsn=5612155.f9c194&utm_source=refersion&utm_medium=affiliate&utm_campaign=5612155.f9c194
Use the code BOBSGLUESTUFF to get 10% off site-wide
I make a percentage on sales from this link, at no additional cost to the buyer.
My Website: bobswoodstuff.com
Instagram: instagram.com/bobswoodstuff
In this Quick Tip I show how to use CA glue with a straight edge to make your table saw into a jointer. If you're like me and don't have a jointer, this can be a very useful technique to get a flat straight edge on your boards.
It is possible to do this with double sided tape, but it works better with cyanoacrylate glue (CA glue).
You can get Starbond CA glue on their website here: (affiliate link)
starbond.com/?rfsn=5612155.f9c194&utm_source=refersion&utm_medium=affiliate&utm_campaign=5612155.f9c194
Use the code BOBSGLUESTUFF to get 10% off site-wide
I make a percentage on sales from this link, at no additional cost to the buyer.
My Website: bobswoodstuff.com
Instagram: instagram.com/bobswoodstuff










