Uploaded December 2017 | Updated September 2026, 2 hours ago

---

This video is how to make a new knurled and polished tailstock lock lever handle from aluminum round stock on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Thread Checker: amzn.to/2EPIuXW
Tap and Die Set: amzn.to/2pBk6SB
Green Loctite: amzn.to/2qhVSAd
Red Loctite: amzn.to/2pMgf5r
Neodymium Magnets: amzn.to/2xDOnIc
Knurling Tool: amzn.to/2pI4fCq

Lathe: amzn.to/2nVBrEc

Stuff on the lathe:
Quick Change Tool Holder: amzn.to/2oZtFee
Tailstock Drill Chuck: amzn.to/2pmE0jX

Lathe tools:
Boring Bar: amzn.to/2pmy0b1
Carbide Tools: amzn.to/2oRZWax
Parting Tool: amzn.to/2nVCeW1
Center Bits: amzn.to/2oRRV5n
Drill Bits: amzn.to/2oz9W76

Other stuff:
Cutting oil: amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: imgur.com/KIEzu92

The real version of the motor controller: amzn.to/2orw43F
Datasheet for the KBIC-120: galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: olduhfguy.com

Music:
Hip Hop Rap Instrumental (Crying Over You) by Chris Morrow 4 soundcloud.com/chris-morrow-3
Creative Commons — Attribution 3.0 Unported— CC BY 3.0
http://creativecommons.org/licenses/b...
Music promoted by Audio Library youtu.be/hiYs5z4xdBU

Experimental by strange day soundcloud.com/strange-day
Creative Commons — Attribution 3.0 Unported— CC BY 3.0
http://creativecommons.org/licenses/b...
Music promoted by Audio Library youtu.be/BWjuid5DJuw