Uploaded February 2016 | Updated September 2026, 3 weeks ago
Weber State University (WSU) - Automotive Technology Department - Transmission Lab. This is the first in a series of videos on universal joints, constant velocity joints, and driveshafts. We will cover their history, proper nomenclature (names), joint types, diagnostics, service procedures, service tools, and more.
Timeline
0:00 Start
0:08 Introduction
4:13 Differences in universal joints
5:29 Differences in constant velocity joints
7:04 Universal joint service tools and procedures
8:54 Measurements of universal joint axial endplay and centering
10:19 Driveshaft and driveline types
12:20 Constant velocity driveshafts and drivelines
14:00 Series summary
This video series helps partially cover the following NATEF Master Tasks:
3.D.1. Diagnose constant-velocity (CV) joint noise and vibration concerns; determine necessary action.
3.D.2. Diagnose universal joint noise and vibration concerns; perform necessary action.
3.D.4. Inspect, service, and replace shafts, yokes, boots, and universal/CV joints.
3.D.5. Check shaft balance and phasing; measure shaft runout; measure and adjust driveline angles.
3.E.4. Measure drive axle flange runout and shaft end play; determine necessary action.
Subscribe to the weberauto Youtube channel for more great videos.
Visit the following website for information on how to attend our school and obtain an associate's degree or bachelor's degree in Automotive Technology.
http://www.weber.edu/automotive
This video was created and edited by Professor John D. Kelly at WSU. For a full biography, see http://www.weber.edu/automotive/J_Kelly.html
Weber State University (WSU) - Automotive Technology Department - Transmission Lab. This is the first in a series of videos on universal joints, constant velocity joints, and driveshafts. We will cover their history, proper nomenclature (names), joint types, diagnostics, service procedures, service tools, and more.
Timeline
0:00 Start
0:08 Introduction
4:13 Differences in universal joints
5:29 Differences in constant velocity joints
7:04 Universal joint service tools and procedures
8:54 Measurements of universal joint axial endplay and centering
10:19 Driveshaft and driveline types
12:20 Constant velocity driveshafts and drivelines
14:00 Series summary
This video series helps partially cover the following NATEF Master Tasks:
3.D.1. Diagnose constant-velocity (CV) joint noise and vibration concerns; determine necessary action.
3.D.2. Diagnose universal joint noise and vibration concerns; perform necessary action.
3.D.4. Inspect, service, and replace shafts, yokes, boots, and universal/CV joints.
3.D.5. Check shaft balance and phasing; measure shaft runout; measure and adjust driveline angles.
3.E.4. Measure drive axle flange runout and shaft end play; determine necessary action.
Subscribe to the weberauto Youtube channel for more great videos.
Visit the following website for information on how to attend our school and obtain an associate's degree or bachelor's degree in Automotive Technology.
http://www.weber.edu/automotive
This video was created and edited by Professor John D. Kelly at WSU. For a full biography, see http://www.weber.edu/automotive/J_Kelly.html
