Uploaded November 2021 | Updated September 2026, 1 hour ago
In this video, I show 3 ways to burn the Arduino bootloader. I show doing it with both ATMEGA 328 and 328P. First I used the TL866CS to program it, The t56 and TL866II can also do this same way. Then I show how to use an Arduino Uno as ISP. This is the point where I show you how to overcome the signature error in AVRdude for using a 328 instead of 328P. Where it's looking for 1E 95 0F instead of 1E 95 14. Last I show how to program it once it's in a project instead of a Devboard. For this, I actually don't put the bootloader on I just flash it with the BIN but you can also put the bootloader on the same way.
Official guide:
arduino.cc/en/Tutorial/BuiltInExamples/ArduinoISP
Amazon affiliate link:
New "Minipro": amzn.to/3cxaHWB
Timestamps:
Minipro 2:45
Uno as ISP: 4:38
Out of Devboard: 10:25
In this video, I show 3 ways to burn the Arduino bootloader. I show doing it with both ATMEGA 328 and 328P. First I used the TL866CS to program it, The t56 and TL866II can also do this same way. Then I show how to use an Arduino Uno as ISP. This is the point where I show you how to overcome the signature error in AVRdude for using a 328 instead of 328P. Where it's looking for 1E 95 0F instead of 1E 95 14. Last I show how to program it once it's in a project instead of a Devboard. For this, I actually don't put the bootloader on I just flash it with the BIN but you can also put the bootloader on the same way.
Official guide:
arduino.cc/en/Tutorial/BuiltInExamples/ArduinoISP
Amazon affiliate link:
New "Minipro": amzn.to/3cxaHWB
Timestamps:
Minipro 2:45
Uno as ISP: 4:38
Out of Devboard: 10:25
