TUTORIAL: How to Make Your Own DIY PCBs! - Part 2 - Quick, Cheap & Easy! (Toner, Acetone & No Heat) @antonycartwright
TUTORIAL: How to Make Your Own DIY PCBs! - Part 2 - Quick, Cheap & Easy! (Toner, Acetone & No Heat)  @antonycartwright
Uploaded September 2018 | Updated November 2026, 3 hours ago
This is a 2-part series on how to easily, quickly & cheaply make your very own PCBs! Part 1 is an introduction, explaination and me preparing the board for etching! Part 2 is the etching, drilling and evaluation.

You will need:
Copper Clad PCBs/Boards
Acetone
Isopropanol
Ferric Chloride
Travel Magazine/Brochure
Mixing Bottle & Syringe
Wire Wool
2 x Food Trays
Tissue Paper
Scissors
Drill & 0.8mm Drill Bit
Laser Printer

For those who wish to support the channel, my Patreon account is here: patreon.com/antonycartwright
TUTORIAL: How to Make Your Own DIY PCBs! - Part 2 - Quick, Cheap & Easy! (Toner, Acetone & No Heat)Kit Build #3 - A Beautiful Glowing/Pulsating Heart - (And Chatting About Women and Electronics)TUTORIAL: How to Quickly Get Started with Arduino Micro SD Card Reader / Writer Module DIY - Part 3INVESTIGATING: My DIY Offgrid Solar Power System - September 2018TUTORIAL: How to Wire Up, Code & Read Input From an LDR Light Dependent Resistor Arduino (Part 2)TUTORIAL: Arduino RGB LED! How they work, How to wire up and code. Back to Basics - 2.TUTORIAL: How to Wire up & Code DHT11 Temperature & Humidity Sensor - Set Up - Arduino (Part 1)Broken Lithium 18650 Charger - Astrolux VC04 - Whats wrong?DIY Arduino Bluetooth (BLE) Device - Connect to Phone! (C++, MAUI, C#) Intro (1/4)TUTORIAL: Ubuntu Mail Server - Install Postfix, Dovecot & Test in 16 Minutes! (22.04)INVESTIGATING: Making A Super Cheap Spot Welder! Will it work?!?INVESTIGATING: My New Solar PCBs - Version 4 (Arduino, Esp32, Offgrid)
Antony Cartwright (Electronics & Code) |

TUTORIAL: How to Make Your Own DIY PCBs! - Part 2 - Quick, Cheap & Easy! (Toner, Acetone & No Heat)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER