Turning 3D Printing Waste into a Skull @BrothersMake
Turning 3D Printing Waste into a Skull  @BrothersMake
Uploaded December 2023 | Updated November 2026, 4 days ago
We’ve seen quite a few people trying out melting down 3D printing waste into these skull moulds, so we thought we’d give it a go ourselves!

After a few tries of just putting the PLA in one of these silicone candle moulds, letting it melt down, and repeating the process over and over again, we thought that while it worked well - it could be sped up significantly.

So instead, we dumped a load of PLA waste onto our panini press, let it melt, and then cut it up into little pillows. Once cool, this gave us far denser pieces of plastic to work with. Then, when we loaded them up into the mould, there were far less air bubbles, and it took about a quarter of the time to completely fill.

We also wanted to experiment with colouring the plastic, so we added some gold micah powder to the inside of the mould, which worked great. We’re unsure how this would affect its future recyclability, so if you know - we’d love to hear! Otherwise, the effect without the powder looks awesome anyway so we’ll probably just go with the natural look next time.

💀
Turning 3D Printing Waste into a SkullThe Barbie BrickHow We Recycle Toothpaste Tubes 🦷♻️Are Plastic Bags REALLY that Bad for the Planet?New Stool from Old TrashPlant Pots made from Recycled PlasticYour First Recycled Plastic ProjectIs THIS Better than 3D Printing?18 attempts later... we finally made it.How to Make a Recycled Plastic Cutting Board 🥒Fixing Wood with Recycled Plastic ♻️Recycling plastic bags at home (using an iron)
Brothers Make |

Turning 3D Printing Waste into a Skull

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER