Trying To Cast A Blade Using Welding Thermite @BillGilmour519
Trying To Cast A Blade Using Welding Thermite  @BillGilmour519
Uploaded August 2017 | Updated November 2026, 3 hours ago
I made up a small crucible with a hole in the bottom and also made a crude blade shaped mold from a hard firebrick. The idea was to get liquid steel from the welding thermite to flow onto the firebrick mold shape. This did not work perfectly as one side of the guard did not form. I will try this again using a proper cope and drag sand mold. A good mold should provide a far better result.
Trying To Cast A Blade Using Welding ThermiteHydraulic Squash #12 - Wrist WatchAir Cannon #131 - Cal .410 Rifled Barrel TestAir Cannon #114 - Radio Shot With BBs Ball Chain And A Caulking TubeCopper Chemistry - Copper CarbonateSoxhlet Extraction #3 - Peony Flowers, Ether And EthanolDistillation Of Turpentine For PinenesCopper Chemistry - Chevreuls SaltAir Cannon #123 - What Does It Take To Pop A 25 CRT?Soxhlet Extraction #4 - Hot Chili PowderCapacitor Bank #67 - Fluorescent TubesMagicians Flash Paper - Nitration Of Cellulose
Bill Gilmour |

Trying To Cast A Blade Using Welding Thermite

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER