Trinus 2-in-1 3D Printer/Laser Engraver - Test Engraving on Fake Leather (Front and Top down views) @RetromanIE
Trinus 2-in-1 3D Printer/Laser Engraver - Test Engraving on Fake Leather (Front and Top down views)  @RetromanIE
Uploaded January 2017 | Updated November 2026, 4 days ago
A test of my new Kodama Trinus 3D printer/laser engraver.
I used some fake leather material that was laying around and engraved a Hylian shield on it. Had to engrave at slow speed to get a good result (1mm/sec).
Bonus clip at the end of what it looks like inside the enclosure when engraving (the main video is recorded from the safety of outside the laser safe enclosure).
Trinus 2-in-1 3D Printer/Laser Engraver - Test Engraving on Fake Leather (Front and Top down views)KIRI Engine test scansVase/Spiralize mode with home made PLA and 0.8mm nozzleThe Best of RTEs Bosco - Volume 2 - Episode 01Star Wars: The Force Awakens Two LP Hologram VinylPO-20 Arcade Pocket Operator SynthesizerStar Wars: The Force Awakens Two LP Hologram VinylStrikers 1945 (ストライカーズ1945) - Sega Saturn - XCAPTURE-1/XRGB-Mini FramemeisterRidge Racer (Arcade) and Ridge Racer 7 (PS3) comparisonCustom Purple Commodore 64 Paint JobFLIR One v2 (iOS) - Video of my PC internalsAmiga 600 HxC Floppy Emulator - SD Card Manager Software
RetromanIE |

Trinus 2-in-1 3D Printer/Laser Engraver - Test Engraving on Fake Leather (Front and Top down views)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER