Uploaded March 2024 | Updated September 2026, 23 hours ago

---

Permanently stop your stick drift on Xbox Series S and X controllers.
After repeated attempts at cleaning the potentiometer on the right stick to stop upward drift on a controller I bought on eBay, I decided a replacement was in order, BUT! You don't have to replace the whole joystick assembly, it's much easier to just replace the 10K ohm trim pot that controls the motion input.

10k ohm trim pot gaskets x20:
amzn.to/4afrqcS

Get all your modding gear from ZedLabz! (discount applied automatically)
Save money and support my channel by using the affiliate link below:
zedlabz.com/?ref=d4S68RLAaM6Hfh

Visit my Amazon store front:
amazon.co.uk/shop/joebleeps

Affiliate link disclaimer: I may receive a commission if you use the above links to purchase items - you will be supporting this channel at no additional cost to you, so thanks!

Music: Joe Bleeps
http://www.joebleeps.bandcamp.com​​​​​
soundcloud.com/joebleeps​​​​​

Camera: Sony ZV-1F
Mic: Rode NT USB+
Hardware: 2012 i7 MacBook Pro 2xSSD
Software: iMovie/Keynote

joebleeps.com