Uploaded March 2018 | Updated September 2026, 2 weeks ago
Here's the steps incase you didn't follow the text in the video.
1.
Field Gen, Fuel Pump, and Control to ON position on the control stand.
2.
Local Control & Fuel Pump Breakers to ON position on the back wall panel.
3.
Press C or use the mouse to open the starting compartment. Locate the Prime switch on the right side. Turn the knob to the left and begin priming the engine for 10-12 seconds then turn the knob to the right. If it does not kick over, that means you have primed for too long and must wait 2 minutes to try again.
4.
Set your Isolation Switch on the back wall panel to Run position.
5.
Flip the remaining breakers to the ON position.
6.
That's it to starting the engine in a cold state.
For updates, sneak peeks, and screenshots:
facebook.com/TrainSimUSA
Here's the steps incase you didn't follow the text in the video.
1.
Field Gen, Fuel Pump, and Control to ON position on the control stand.
2.
Local Control & Fuel Pump Breakers to ON position on the back wall panel.
3.
Press C or use the mouse to open the starting compartment. Locate the Prime switch on the right side. Turn the knob to the left and begin priming the engine for 10-12 seconds then turn the knob to the right. If it does not kick over, that means you have primed for too long and must wait 2 minutes to try again.
4.
Set your Isolation Switch on the back wall panel to Run position.
5.
Flip the remaining breakers to the ON position.
6.
That's it to starting the engine in a cold state.
For updates, sneak peeks, and screenshots:
facebook.com/TrainSimUSA
