Too many print failures and I think the filament guides are too tight! #3dprinting #pcgaming #diy @standupg4m3r
Too many print failures and I think the filament guides are too tight! #3dprinting #pcgaming #diy @standupg4m3r
Uploaded September 2024 | Updated September 2026, 2 hours ago
Too many print failures and I think the filament guides are too tight! #3dprinting #pcgaming #diyNew hotend assembly, means new tuning parameters. #3dprinting #pc #gamingVLOG: 11 - 8 Fans Strip For Me3D Printed SFFPC Case with Low Profile GPUMy Attempt at a Cute 3D Printed PC CaseVLOG: 09 - I Messed Up My Heat Inserts... So I 3D Printed a Fix!🔴Livestream: SUG-SHAFT UpdateVLOG: 05 - I Fixed My 10mm CAD Mistake! (Perfectly Thicc & NEW RGB)mATX, Air Cooling, ATX PSU, RTX 5090, No riser, using MakerBeam, and 180x180 #3dprinting +free STLs?VLOG: 23 - Buying the Thermaltake SFX 1000W is Financially Irresponsible🔴Livestream: SUG-FreeBeam-mATX in NAS Mode!Don’t design and 3D print large thin parts this way. #3dprinting #fail
stand_up_g4m3r |

Too many print failures and I think the filament guides are too tight! #3dprinting #pcgaming #diy

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER