Tin / Pewter sculptures crafts from the past - part 2 @HVE
Tin / Pewter sculptures crafts from the past - part 2  @HVE
Uploaded January 2021 | Updated September 2026, 42 minutes ago
In this video i show another set of tin sculptures that are made by Daalderop. These sculptures belong to the series of ambachten van vroeger (oude ambachten) (crafts from the past). These tin models show a lot of details of the face and the tools. Tin casting is shown in the highest level in these sculptures.
if these were made out of plastic, I would have almost no interest in them, but the fact that they are made of metal makes them very likable (at least to the eyes of me).
Today during the lunch break I noticed that sun was shining on my desk and the lighting condition inside my house was a bit good, so i decided to make the second part of this video series.

1- Pottenbakker (potter)
2- Wielenmaker (wheel maker)
3- Smid (blacksmith)
4- Scharensliep (Scissors sharpener) / Messenslijper (knife sharpener)
5- Smid (blacksmith)
6- Tinnegieter (tin caster)
7- Kleermaker (tailor)
8- Bakker (baker)
9- Schoorsteenveger (Chimney sweeper)
10- Slager (butcher)
11- Bierbrouwer (beer brewer)
12- Houtbewerker (woodworker) / Timmerman met schaaf (Carpenter with planer)
13- Lantaarndrager ?(Lantern bearer)

The music is from Youtube audio library
Title: Runaways artist: Silent Partner


Finance:
N=3, subs=124
Available budget (N):
124-100-3*(3+1)=12
Storage limit:
2^ln(124)=28,25
Tin / Pewter sculptures crafts from the past - part 2An attempt to repair a broken plastic lunchbox lidPreparing Sahari ; grilling sheep heart with torch while fighting off wild  animal 😂How to make an app using MATLAB app designer  ( graphical user interface GUI )Rice Engine v2   ( How to make an improved Thermoacoustic Heat Engine )An attempt to feed a cellar spider with red meatHow to add text to a Youtube video after uploadWhat Is the Voltage at the Top of a Solid State Tesla Coil?Why high voltage is used for power transmissionHow to perform an optimization in COMSOL Multiphysics Part 1: parameter optimizationSpark Gap Tesla Coil - part 1: introduction and construction of a simple SGTCHow to repair broken pewter / tin
High Voltage Engineering by MG Niasar |

Tin / Pewter sculptures crafts from the past - part 2

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER