Uploaded September 2025 | Updated September 2026, 2 weeks ago
In today's video I'm going to be working on an inlay cutting board using another one of the cutting board inlay kits I purchased from Cutting It Close. The cutting board is walnut with maple and cherry inlays. The cherry was a little light against the maple, but it darken up nicely after applying the mineral oil. Thanks for watching.
Dave Gatton - davegatton.com
Buy Dave a Coffee - buymeacoffee.com/davegatton
Check out the Masso controller - https://www.masso.com.au/
Cadence Mfg & Design - cadencemfgdesign.com
Use Discount Code: Dave10 to save on your Jenny bit purchases.
Get your Cuttin Board Inlay kit - cicworkshop.com/collections/inlay-kits
Here is some affiliate links to a few of the CNC products I use and recommend. Using these links to shop at Amazon.com help to support my channel.
Thank you.
Bits I used in this project:
Amana #46280 Tapered BallNose - amzn.to/4ly58bt
Whiteside RU1600 1/8" Upcut bit - amzn.to/4mpdMdy
Whiteside 1411 3/4" Round Nose Bit - amzn.to/3Jlm5II
Food grade mineral oil - amzn.to/4luTRJU
CNC Z Axis Tool Setter - amzn.to/4e528kL
Daedalus NL330 CNC 80mm Dust Shoe - amzn.to/4kSrN29
Dave's Social Media Links
Facebook: facebook.com/djgatton
Twitter: @DaveGatton
Instagram: davegatton
#cuttingboardinlaykit #hobbyCNC #Masso
Join this channel to get access to perks:
youtube.com/channel/UC2tIa58oAD8bOTWgJbunz8g/join
In today's video I'm going to be working on an inlay cutting board using another one of the cutting board inlay kits I purchased from Cutting It Close. The cutting board is walnut with maple and cherry inlays. The cherry was a little light against the maple, but it darken up nicely after applying the mineral oil. Thanks for watching.
Dave Gatton - davegatton.com
Buy Dave a Coffee - buymeacoffee.com/davegatton
Check out the Masso controller - https://www.masso.com.au/
Cadence Mfg & Design - cadencemfgdesign.com
Use Discount Code: Dave10 to save on your Jenny bit purchases.
Get your Cuttin Board Inlay kit - cicworkshop.com/collections/inlay-kits
Here is some affiliate links to a few of the CNC products I use and recommend. Using these links to shop at Amazon.com help to support my channel.
Thank you.
Bits I used in this project:
Amana #46280 Tapered BallNose - amzn.to/4ly58bt
Whiteside RU1600 1/8" Upcut bit - amzn.to/4mpdMdy
Whiteside 1411 3/4" Round Nose Bit - amzn.to/3Jlm5II
Food grade mineral oil - amzn.to/4luTRJU
CNC Z Axis Tool Setter - amzn.to/4e528kL
Daedalus NL330 CNC 80mm Dust Shoe - amzn.to/4kSrN29
Dave's Social Media Links
Facebook: facebook.com/djgatton
Twitter: @DaveGatton
Instagram: davegatton
#cuttingboardinlaykit #hobbyCNC #Masso
Join this channel to get access to perks:
youtube.com/channel/UC2tIa58oAD8bOTWgJbunz8g/join
