The Thread Looping Problem on the Spartan 327K has been Solved! @andytubesewing1953
The Thread Looping Problem on the Spartan 327K has been Solved! @andytubesewing1953
Uploaded August 2019 | Updated September 2026, 2 days ago
Yes, the lower thread looping problem is solved! Incorrectly installed Thread Take-up Lever was the cause. Not upper tension, or bobbin holder tension, or check spring, or threading path, or needle, or feed system, or type of bobbin, or timing, but a human error during installation of the thread take-up lever system.
I caused my own grief and frustration!

Totally Looped by Audionautix is licensed under a Creative Commons Attribution license (creativecommons.org/licenses/by/4.0/)
Artist: audionautix.com
The Thread Looping Problem on the Spartan 327K has been Solved!SINGER MODEL 15-91 HOW TO REMOVE, INSTALL, SET HEIGHT OF NEEDLE BARSinger 15-91 Light. Replace, Repair or Rewire. Part Two.Taking a look at some Feuerhelm Tool Screw Holding ScrewdriversThe Andy Tube Channel on YouTubeWhere to Oil & Grease a Singer Model 466COMING IN APRIL 2020 TO ANDY TUBEHow to Check & Set the Height of the Feed Dog on a Singer Model 221 FeatherweightThe Lower Motor Bearing of a Singer PA Style MotorHow to Remove, Repair, Replace the Take-up Lever Singer Model 221 Featherweight Sewing MachineSinger 15-91 Remove, Clean, Install and Adjust the Bobbin Winder System. Part One of Two.The Finishing Touches of a SInger Model 403A Restoration
Andy Tube |

The Thread Looping Problem on the Spartan 327K has been Solved!

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER