The Canary Bomb Drop Project @the-happy-RC-flyer
The Canary Bomb Drop Project  @the-happy-RC-flyer
Uploaded February 2022 | Updated November 2026, 45 minutes ago
Here is my attempt at making a 3D printed bomb drop attachment for my Canary RC plane.

You may have noticed I do not have mid-roll advertising in my videos I feel this may detract from your viewing experience but this does have an effect on my revenues so my Patreon's are very important to me. So if you can join my Pateron it would help me out immensely. Please see link below.

Thanks for watching.

Happy Flying.

Ways to help support my channel.

Please consider becoming a patron of my YouTube channel.
patreon.com/BillClark

By using the affiliate links below I will get a small commission on your purchases but you will pay no more for your order.

General Affiliate Link to RadioMaster:
https://radiomasterrc.myshopify.com?sca_ref=1531318.eCAoyeniWT

General Affiliate Link to Banggood:
banggood.com/custlink/3vGY4DkJdR

General Affiliate Link to Emax:
emaxmodel.com/?ref=5y8gnbt61d
The Canary Bomb Drop ProjectRadioMaster MT12 Setting up Buddy Box TrainingRadioMaster TX15 Setting Up Aileron Differential with GVsOverview of the RadioMaster ER12, ER16 & ER3 Pro Express LRS ReceiversRadioMaster TX15 Setting Up FlaperonsMonthly - What Firmware Has Been Updated June 2022Product Overview RadioMaster XR Series ExpressLRS ReceiversThe Ravens maiden flight did not go to plan!EdgeTX - Servo 90 Degree Movement Mix (Viewer Request)ExpressLRS 250mW & Dynamic Power but the Cemetery Bites Back!OpenTX Setting up flaps with 2 servos on 1 channel using a y-leadOverview of the RadioMaster GX10 Radio
Bill Clark |

The Canary Bomb Drop Project

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER