Vez3D | Teaser: printing with ODrive + Magnum+ @ 250mm/s & 10K @Vez3D | Uploaded May 2021 | Updated October 2024, 12 hours ago.
0.15mm layer height.
250mm/s
10K accel
-Printer: VzBoT (Custom designed/built) 330x330x400mm
-Klipper
-Odrive V3 system
-270 KV motors
-Pressure Advance 0.003
-Input_shaper tuned with Accelerometer
-MGN12 rails Y MGN9 rail
-Magnum+
-PT100
-Hextrudort from HevORT direct drive. miragec79.github.io/HextrudORT
-Custom EVA X carriage modded for Nova https://main.eva-3d.page/
-0.3mm retract
-240C ABS
-250mm/s everywhere
-PEI coted flex plate
-10mm Z smooth rods
-1 single Z motor, 2:1 gear ratio
-0.4mm nozzle
-0.15 layer height
Join us on discord: discord.com/invite/KzgvHXsH5m
0.15mm layer height.
250mm/s
10K accel
-Printer: VzBoT (Custom designed/built) 330x330x400mm
-Klipper
-Odrive V3 system
-270 KV motors
-Pressure Advance 0.003
-Input_shaper tuned with Accelerometer
-MGN12 rails Y MGN9 rail
-Magnum+
-PT100
-Hextrudort from HevORT direct drive. miragec79.github.io/HextrudORT
-Custom EVA X carriage modded for Nova https://main.eva-3d.page/
-0.3mm retract
-240C ABS
-250mm/s everywhere
-PEI coted flex plate
-10mm Z smooth rods
-1 single Z motor, 2:1 gear ratio
-0.4mm nozzle
-0.15 layer height
Join us on discord: discord.com/invite/KzgvHXsH5m