Uploaded September 2022 | Updated September 2026, 2 weeks ago
This is the extended version from the previous video where I go into detail about Thread Tapping. Working out the correct Drill size. Building support jigs and finding centres on round surfaces. The other part of the 3 part series in about making the Wooden Knob with steel bolt insert. Also in a lot of detail. Hope it gets you thinking about how you can add some of these techniques to your work.
VEVOR Tap and Die Combination Set: bit.ly/3PZx4Fo
Use coupon VVPCS to get it for AU$68.99 limited time till October 3rd, 2022
Deals in Australia website: bit.ly/3AWwOTa
Music for this video was obtained free of charge from Bensound.com
Tracks used were an "Hey" followed by "Dreams"
This is the extended version from the previous video where I go into detail about Thread Tapping. Working out the correct Drill size. Building support jigs and finding centres on round surfaces. The other part of the 3 part series in about making the Wooden Knob with steel bolt insert. Also in a lot of detail. Hope it gets you thinking about how you can add some of these techniques to your work.
VEVOR Tap and Die Combination Set: bit.ly/3PZx4Fo
Use coupon VVPCS to get it for AU$68.99 limited time till October 3rd, 2022
Deals in Australia website: bit.ly/3AWwOTa
Music for this video was obtained free of charge from Bensound.com
Tracks used were an "Hey" followed by "Dreams"
