Uploaded May 2026 | Updated November 2026, 3 hours ago
SWITCHBLADE RADIATOR DUCT TESTING STEPS ACCOMPLISHED
In the 1+ minute video below you can see a portion of one of the recent radiator duct tests at the Samson R&D facility. We accomplished this test using the Switchblade flying prototype. As you may recall, this is not the design we're going into production with. We are simply using the original prototype to produce airflow through a duct section that straightens out the flow. Propellers tend to produce a swirl, and we need the airflow going into the radiator test mockup to be straight like it would in flight. To do this we used tubes to capture and straighten out the airflow.
In the video Chief Engineer David Nobles is outside the vehicle giving instruction to Test Engineer Tony Nissen, at the controls of the Switchblade.
The test validated that the flow was fairly straight, and that the tubes didn't block the airflow significantly. We also tested whether we could have the Switchblade prototype engine reach the required temperatures for this test. This is needed as we are using the Switchblade engine coolant to run through the radiator test section that will be behind the Switchblade. Using this test setup for these future tests, we can gauge whether the radiator and radiator ducts are working as they were designed.
SWITCHBLADE RADIATOR DUCT TESTING STEPS ACCOMPLISHED
In the 1+ minute video below you can see a portion of one of the recent radiator duct tests at the Samson R&D facility. We accomplished this test using the Switchblade flying prototype. As you may recall, this is not the design we're going into production with. We are simply using the original prototype to produce airflow through a duct section that straightens out the flow. Propellers tend to produce a swirl, and we need the airflow going into the radiator test mockup to be straight like it would in flight. To do this we used tubes to capture and straighten out the airflow.
In the video Chief Engineer David Nobles is outside the vehicle giving instruction to Test Engineer Tony Nissen, at the controls of the Switchblade.
The test validated that the flow was fairly straight, and that the tubes didn't block the airflow significantly. We also tested whether we could have the Switchblade prototype engine reach the required temperatures for this test. This is needed as we are using the Switchblade engine coolant to run through the radiator test section that will be behind the Switchblade. Using this test setup for these future tests, we can gauge whether the radiator and radiator ducts are working as they were designed.










