Uploaded April 2014 | Updated November 2026, 3 hours ago
Here is a video of the Switchblade Ground Test Prototype going through the slalom course. For more information please go to our website at www.SamsonSky.com!
Here is a video of the Switchblade Ground Test Prototype going through the slalom course. For more information please go to our website at www.SamsonSky.com!
![3D PRINTING ACTION: EXHAUST TUBING [2021]
Samson engineer Tanner Vaughn is printing exhaust tubing in small sections to be able to create a three-into-one tube design inside the existing engine bay, while the exhaust system is on the Switchblade. This will help us verify that the resulting exhaust design will perform as intended.
You can check out more on the Samson Sky Switchblade at: https://www.samsonsky.com
* Resources *
Phone: (855) 7-SAMSON
Website: https://www.samsonsky.com/
Facebook: https://www.facebook.com/SamsonMotorsSwitchblade/
Instagram: https://www.instagram.com/samsonswitchblade/?hl=en
Twitter: https://twitter.com/FlyingSportsCar
#flyingcar #exhaustsystem #shorts 3D PRINTING ACTION: EXHAUST TUBING [2021]](https://i.ytimg.com/vi/kr8aTcD9xV4/mqdefault.jpg)



![Switchblade Rudders Under Pilot Control For First Time [May 2020]
The Switchblade rudders have been tested and worked extensively with the tail off the body. Here is a short video clip of the rudders and tail installed on the vehicle, working under pilot direction from the cockpit. This is yet another verification step being done as part of our flight test preparation.
Visit our website for more info: https://www.samsonsky.com/specs/
* Resources *
Phone: (855) 7-SAMSON
Website: https://www.samsonsky.com/
Facebook: https://www.facebook.com/SamsonMotorsSwitchblade/
Instagram: https://www.instagram.com/samsonswitchblade/?hl=en
Twitter: https://twitter.com/FlyingSportsCar Switchblade Rudders Under Pilot Control For First Time [May 2020]](https://i.ytimg.com/vi/lmDquTG4yb0/mqdefault.jpg)





