Sunbeam Alpine Restoration (Part I - Restoring the metalwork) @TheSunbeamAlpineChannel
Sunbeam Alpine Restoration (Part I - Restoring the metalwork)  @TheSunbeamAlpineChannel
Uploaded September 2018 | Updated November 2026, 3 hours ago
This video is about the resoration of a completely rusted out 1965 Series V Sunbeam Alpine. The first part covers repairing the metal work of the body shell of the car. Wherever possible original panels were retained and repaired. Where replacements were needed we either had new panels made to the original specification or, when panels were unobtainable, we fabricated them ourselves. The aim was to make the car as true as possible with neat, even panel gaps before it goes to the bodyshop for final paint. Part II will be published in due course and will cover how we epoxy primed and rust treated the car to prevent her rusting out again in the future.
Sunbeam Alpine Restoration (Part I - Restoring the metalwork)National 2021 (14/08/21)Sunbeam Alpine: Replacing the Heater MatrixSunbeam Alpine: Prop shaft.  Replacing Universal Joints.Sunbeam Alpine: Fuel Tank RestorationSunbeam Alpine Owners Club U.K.  National 2022Sunbeam Alpine Series III-V & Tiger: Fitting the side windows and adjusting the window channels.The Sunbeam Alpine ChannelSunbeam Alpine: Rear Hub Seal Replacement  REMIXSunbeam Alpine Series III-V & Tiger: Soft top installation (SUPPLEMENTAL)Sunbeam Alpine & Tiger: Fitting a Tonneau CoverSunbeam Alpine Steering Idler Overhaul
The Sunbeam Alpine Channel |

Sunbeam Alpine Restoration (Part I - Restoring the metalwork)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER