Uploaded April 2011 | Updated September 2026, 2 hours ago
I was tired of bullshit Piezo crystal ignition systems. With 30,000 volts, this should do the trick.
The stun gun is a VERY cheap item. I had to tear mine apart to solder new wires onto both leads. From there, run them to two aluminum screws, and then run them into the combustion chamber.
Remember, this stuff is NOT for the weak. Douse everythign remotely connected with liquid electrical tape before using it. I'm not sure about you guys, but 30,000 volts would certainly tickle quite a bit
I was tired of bullshit Piezo crystal ignition systems. With 30,000 volts, this should do the trick.
The stun gun is a VERY cheap item. I had to tear mine apart to solder new wires onto both leads. From there, run them to two aluminum screws, and then run them into the combustion chamber.
Remember, this stuff is NOT for the weak. Douse everythign remotely connected with liquid electrical tape before using it. I'm not sure about you guys, but 30,000 volts would certainly tickle quite a bit
