Uploaded May 2024 | Updated November 2026, 11 hours ago
I've been really enjoying my custom modded TD-3, so I thought I'd do a comparison with the original. I almost forgot how middy it sounded! Mine is hard to the left, stock is hard to the right. Since the parameters aren't equivalent any more, I tried to compare them as fairly as I could.
A little echo was used to fill in space and hear them in a more realistic context, no EQ was used.
If there's any enthusiasm, I may release complete notes and even make you one for a modest fee. (We can talk about additional customization.)
Briefly, what I did:
Right off the bat my CUTOFF goes much lower, but this doesn't really constitute a mod since it has an internally adjustable pot for this.
Tone improvement via power cap increase.
RES is increased quite a bit, so much so that in certain phase regions it can "bubble" a little on its own, since I crudely didn't alter anything but the final resistor. At first I was on the fence about the bubbling, but it's a neat effect.
Adjustable "PULSE WIDTH" for the square to make it more square like, or thinner and more saw like as desired.
AMP ATTACK increased slightly.
AMP DECAY greatly increased.
Adjustable AMP RELEASE knob added.
ENV scale knob added (back left).
MIN DECAY TIME knob added.
MAX DECAY TIME increased.
A few other fiddly little tone adjustments which I consider improvements.
Might change the FILTER IN jack to FILTER CV IN, and add a two way pot to mix internal SAW or SQR in with that. Also been thinking an ACCENT TRIG OUT would be a good addition for linking it with modular. What do you think?
I've been really enjoying my custom modded TD-3, so I thought I'd do a comparison with the original. I almost forgot how middy it sounded! Mine is hard to the left, stock is hard to the right. Since the parameters aren't equivalent any more, I tried to compare them as fairly as I could.
A little echo was used to fill in space and hear them in a more realistic context, no EQ was used.
If there's any enthusiasm, I may release complete notes and even make you one for a modest fee. (We can talk about additional customization.)
Briefly, what I did:
Right off the bat my CUTOFF goes much lower, but this doesn't really constitute a mod since it has an internally adjustable pot for this.
Tone improvement via power cap increase.
RES is increased quite a bit, so much so that in certain phase regions it can "bubble" a little on its own, since I crudely didn't alter anything but the final resistor. At first I was on the fence about the bubbling, but it's a neat effect.
Adjustable "PULSE WIDTH" for the square to make it more square like, or thinner and more saw like as desired.
AMP ATTACK increased slightly.
AMP DECAY greatly increased.
Adjustable AMP RELEASE knob added.
ENV scale knob added (back left).
MIN DECAY TIME knob added.
MAX DECAY TIME increased.
A few other fiddly little tone adjustments which I consider improvements.
Might change the FILTER IN jack to FILTER CV IN, and add a two way pot to mix internal SAW or SQR in with that. Also been thinking an ACCENT TRIG OUT would be a good addition for linking it with modular. What do you think?










