Uploaded October 2025 | Updated November 2026, 3 hours ago
homebuildingandrepairs.com/stairs/index.html - Building stairs on a sloping walkway or uneven landing is a classic construction headache. How do you get level treads and consistent riser heights when the ground won't cooperate?
This video provides a practical, field-tested solution for laying out bracket or dadoed stair stringers on a non-level surface. I'll show you why you should measure your total rise from the center of the stairway (where people walk) and then demonstrate how to adjust the top and bottom of each stringer to compensate for the slope. This method ensures your treads are perfectly level, avoiding trip hazards and different riser heights from one side to the other.
Also in this video: I share my non-engineer (but heavily experienced) opinion on stringer lumber size. Learn why I've never used less than a 4x12 for my stringers, even on short stairways, and why 2x12s might not be enough without significant support.
DISCLAIMER: I am not a structural engineer and this is not engineering advice. This information is based on decades of personal building experience. Always check your local building codes for specific requirements on riser height and structural support.
homebuildingandrepairs.com/stairs/index.html - Building stairs on a sloping walkway or uneven landing is a classic construction headache. How do you get level treads and consistent riser heights when the ground won't cooperate?
This video provides a practical, field-tested solution for laying out bracket or dadoed stair stringers on a non-level surface. I'll show you why you should measure your total rise from the center of the stairway (where people walk) and then demonstrate how to adjust the top and bottom of each stringer to compensate for the slope. This method ensures your treads are perfectly level, avoiding trip hazards and different riser heights from one side to the other.
Also in this video: I share my non-engineer (but heavily experienced) opinion on stringer lumber size. Learn why I've never used less than a 4x12 for my stringers, even on short stairways, and why 2x12s might not be enough without significant support.
DISCLAIMER: I am not a structural engineer and this is not engineering advice. This information is based on decades of personal building experience. Always check your local building codes for specific requirements on riser height and structural support.










