Uploaded July 2020 | Updated November 2026, 3 hours ago
In this video I start taking apart an old Ainslie sock knitting machine. I point out a few missing parts. Then I get a little stuck when the cylinder didn't separate from the carriage.
I'm going to try and separate these in the future, but if anyone who is more familiar with these machines can give me a tip I'd appreciate it. I start talking about this problem at 7:30.
Restoring Circular Sock Machine Series:
Part 1 (Taking It Apart) - youtube.com/watch?v=K65_NwQ7w7M
Part 2 (Removing and Repair Damaged Cylinder) - youtube.com/watch?v=lF4eTH4bCCI
Part 3 (Adding Needles) - youtube.com/watch?v=p8UKglS06cA
Part 4 (3D Printed Cylinder and First Knit) - youtube.com/watch?v=kTiK7JlT7CY
In this video I start taking apart an old Ainslie sock knitting machine. I point out a few missing parts. Then I get a little stuck when the cylinder didn't separate from the carriage.
I'm going to try and separate these in the future, but if anyone who is more familiar with these machines can give me a tip I'd appreciate it. I start talking about this problem at 7:30.
Restoring Circular Sock Machine Series:
Part 1 (Taking It Apart) - youtube.com/watch?v=K65_NwQ7w7M
Part 2 (Removing and Repair Damaged Cylinder) - youtube.com/watch?v=lF4eTH4bCCI
Part 3 (Adding Needles) - youtube.com/watch?v=p8UKglS06cA
Part 4 (3D Printed Cylinder and First Knit) - youtube.com/watch?v=kTiK7JlT7CY










