PaulsonTraining | Single Screw Extrusion - Effects of Pressure, Temperature, and Flow @PaulsonTraining | Uploaded 11 years ago | Updated 2 hours ago
This industry-standard training program uses state-of-the art 3D animation technology to teach the fundamentals of the single screw process, including parts and operation of the extruder, common plastics used in the extrusion process, how each extruder control functions, best-practices safety procedures, troubleshooting common extrusion problems and much more.
This lesson describes the characteristics and practical effects of plastic flow in extrusion. Including how and why orientation occurs; the interrelationship between flow and viscosity, how plastic flow behavior is measured, and how viscosity is affected by temperature, pressure and molecular length.
Also available in Spanish.
Below are listed all of the 9 lessons in the Single Screw Extrusion Training Course:
Lesson 1: The Single Screw Extruder: Parts and Operation
Lesson 2: The Structure of Plastic Raw Materials
Lesson 3: The Characteristics of Plastics for Extrusion
Lesson 4: Effects of Pressure, Temperature and Flow
Lesson 5: Optimizing Extruder Controls -- Part 1
Lesson 6: Optimizing Extruder Controls -- Part 2
Lesson 7: Safety, Pre-Start and Start-Up Procedures
Lesson 8: Steady-State Operation, Shutdown and Maintenance Procedures
Lesson 9: Single Screw Extruder Troubleshooting
This industry-standard training program uses state-of-the art 3D animation technology to teach the fundamentals of the single screw process, including parts and operation of the extruder, common plastics used in the extrusion process, how each extruder control functions, best-practices safety procedures, troubleshooting common extrusion problems and much more.
This lesson describes the characteristics and practical effects of plastic flow in extrusion. Including how and why orientation occurs; the interrelationship between flow and viscosity, how plastic flow behavior is measured, and how viscosity is affected by temperature, pressure and molecular length.
Also available in Spanish.
Below are listed all of the 9 lessons in the Single Screw Extrusion Training Course:
Lesson 1: The Single Screw Extruder: Parts and Operation
Lesson 2: The Structure of Plastic Raw Materials
Lesson 3: The Characteristics of Plastics for Extrusion
Lesson 4: Effects of Pressure, Temperature and Flow
Lesson 5: Optimizing Extruder Controls -- Part 1
Lesson 6: Optimizing Extruder Controls -- Part 2
Lesson 7: Safety, Pre-Start and Start-Up Procedures
Lesson 8: Steady-State Operation, Shutdown and Maintenance Procedures
Lesson 9: Single Screw Extruder Troubleshooting