Uploaded February 2021 | Updated September 2026, 1 week ago
Just putting up some sound tests I had on a couple of rebuilds.
Recently got a custom POM half plate for the Jaguar. Excuse the slightly crooked keys, I milmaxed my pcb and some switches are not sitting right. Gotta get a new PCB to solder but for now, this will do.
Board:
Polycarbonate Singa Jaguar
POM Half Plate
Lavender Switches Lubed with Krytox 205g0, 63.5g Slow Sprit Springs with GPL 105, Deskey Filmed.
Case Foam Added
GMK Darling
Impressions:
Sounds super damn nice, at first I was taken aback by how soft it felt and I personally did not like it too much, but after using it for a bit, it definitely grows on you.
I'm actually an idiot that forgot that milmax and half plates don't work too well since the switches don't sit very tight on the pcb. will have to redo the build later when I can source another pcb but for now, it stays put well enough.
Lavenders sound good too
Just putting up some sound tests I had on a couple of rebuilds.
Recently got a custom POM half plate for the Jaguar. Excuse the slightly crooked keys, I milmaxed my pcb and some switches are not sitting right. Gotta get a new PCB to solder but for now, this will do.
Board:
Polycarbonate Singa Jaguar
POM Half Plate
Lavender Switches Lubed with Krytox 205g0, 63.5g Slow Sprit Springs with GPL 105, Deskey Filmed.
Case Foam Added
GMK Darling
Impressions:
Sounds super damn nice, at first I was taken aback by how soft it felt and I personally did not like it too much, but after using it for a bit, it definitely grows on you.
I'm actually an idiot that forgot that milmax and half plates don't work too well since the switches don't sit very tight on the pcb. will have to redo the build later when I can source another pcb but for now, it stays put well enough.
Lavenders sound good too
