Setup of the Flasks  - Video 2 @craigdabler-thediycastings7511
Setup of the Flasks  - Video 2  @craigdabler-thediycastings7511
Uploaded June 2022 | Updated November 2026, 2 hours ago
How to prepare the injection waxes by attaching them to the sprue bases. This is how I do it.

***Also notice I included one X-One resin. While I know little about resin this type from BlueCast has actually worked on occasion so I am eager to try it again.
Setup of the Flasks  - Video 2The New Tool in ActionRed Clay Casting: Step One - Blocking Out the WaxPrepping the Flasks for BurnoutSand Casting 1 1/2 Ounces of Sterling Silver - Vacuum Assist Flask SetupCasting with the new vacuum system and a propane mini oven.Removing the Burnt Black Sand and What to do with It.The Ingot MakerSand Casting - Adding Width to a Band - Video TwoInjecting the Mold With Wax: Video FourStep Three of Four: Preparation of the Two Flask Halves for CastingUsing a Tiny Drill Bit in a Platinum Ring
Craig Dabler - The DIY Castings Guy |

Setup of the Flasks - Video 2

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER