Rob Shuster / SideWinder Drums | Setting up a Tool Setter using LinuxCNC and VCarve Pro @sidewinderdrums | Uploaded 10 months ago | Updated 1 hour ago
In this video I set up a tool setter in LinuxCNC that runs on gcode generated by Vectric CAD/CAM.
Here is a link to the files used in this video.
drive.google.com/drive/folders/1ukd53nT2AtTzUd0djRe7txIiCo8a3bBA?usp=drive_link
Link to my SideWinder Drums Facebook page:
facebook.com/SidewinderDrums
Link to my Facebook woodworking page:
facebook.com/SawCNC
In this video I set up a tool setter in LinuxCNC that runs on gcode generated by Vectric CAD/CAM.
Here is a link to the files used in this video.
drive.google.com/drive/folders/1ukd53nT2AtTzUd0djRe7txIiCo8a3bBA?usp=drive_link
Link to my SideWinder Drums Facebook page:
facebook.com/SidewinderDrums
Link to my Facebook woodworking page:
facebook.com/SawCNC