Screw cutting an ER32 collet holder @enotsengineering
Screw cutting an ER32 collet holder  @enotsengineering
Uploaded July 2023 | Updated November 2026, 14 hours ago
Cutting a thread for an ER32 collet nut
setup gears, tool and test cut. then finish thread
** I set the 29 Deg angle the wrong side.The thread form was corrected when I took the finishing cuts using the cross slide 90 deg to the part.
Screw cutting an ER32 collet holderRadius cutter (Ball Cutter) for the latheChecking the lathe speedtaper turning +tools & surface finishMaking a water butt depth gaugeMaking a knurling tool from a kitindexing ring questionsChristmas town for childrenfitting a rev counter on the latheTurning Nylon barPower drive part 2Internal micrometer & Live centre
enots engineering |

Screw cutting an ER32 collet holder

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER