Uploaded August 2017 | Updated September 2026, 2 weeks ago
In this video I will do a short product review for the ISDS205X:
Dual-channel digital oscilloscope, "low-cost, high-performance" as the design goals. well-designed bandwidth of 20M, 48M sampling rate, 2 channels, alternating support X-T and XY alternating pattern of two-channel virtual oscilloscope, spectrum analyzer, data recorder.
You can buy it online with free shipping at Bangoogd:
banggood.com/ISDS205X-Virtual-PC-USB-Oscilloscope-DDS-Signal-and-Logic-Analyzer-p-1103052.html?p=9R09143243493201512Z
patreon.com/weblearning
In this video I will do a short product review for the ISDS205X:
Dual-channel digital oscilloscope, "low-cost, high-performance" as the design goals. well-designed bandwidth of 20M, 48M sampling rate, 2 channels, alternating support X-T and XY alternating pattern of two-channel virtual oscilloscope, spectrum analyzer, data recorder.
You can buy it online with free shipping at Bangoogd:
banggood.com/ISDS205X-Virtual-PC-USB-Oscilloscope-DDS-Signal-and-Logic-Analyzer-p-1103052.html?p=9R09143243493201512Z
patreon.com/weblearning
![Raspberry Pi Zero W as Wi-Fi Debugger
https://www.patreon.com/weblearning
Or tip me: paypal.me/weblearning1
In this video I will use the Raspberry Pi Zero W as a stand alone SWD debugger with no ST-Link. I will show the complete procedure ( with mistakes that I made ).
0:00 - introduction
0:21 - How to connect the Pi to the Nucleo
1:35 - setting the Raspberry Pi
1:55 - Installing Openocd
2:22 - setting the openocd.cfg file
3:34 - setting the raspberrypi-native.cfg file
5:00 - CubeIDE
6:27 - correct settings of the openocd.cfg
**********************
*** raspberrypi-native.cfg ***
bcm2835gpio_swd_nums 25 24
bcm2835gpio_trst_num 7
bcm2835gpio_srst_num 18
**********************
*** opeocd.cfg ***
source [find raspberrypi-native.cfg]
transport select swd
bindto 0.0.0.0
set WORKAREASIZE 0x2000
#type of STM32
source [find ../target/stm32l0.cfg]
#reset_config srst_only
#srst_nogate
adapter_nsrst_delay 100
adapter_nsrst_assert_width 100
init
targets
reset hal
**********************
https://learn.adafruit.com/programming-microcontrollers-using-openocd-on-raspberry-pi/wiring-and-test
My social accounts :
http://instagram.com/WebLearning1
http://twitter.com/WebLearning1
http://www.facebook.com/WebLearning1
Thanks. Raspberry Pi Zero W as Wi-Fi Debugger](https://i.ytimg.com/vi/uIFODFQc_P8/mqdefault.jpg)









