Salvaging a worn R380 casing @BritannicaRestorations
Salvaging a worn R380 casing  @BritannicaRestorations
Uploaded October 2026 | Updated November 2026, 2 hours ago
This box was given to me a long time ago
It is a Discovery 300Tdi box - owner said it was fine, but it shifted badly on the test bench - the shaft was lose in the casing, and making gear selection difficult.
Not a common problem

Sliver solder was used to install the bush - although very little was used, 1 ounce of solder was C$127.00!

Subscriptions: britrest.com/subscriptions

patreon.com/britrest

paypal.me/britrest2018

Shop britrest.com/shop

Email britrest@britrest.com

This video is produced for entertainment purposes only and Britannica Restorations nor Michael Wesson and/or guests featured in this video shall not, in any way or measure, be held accountable or responsible for any damages related to attempted repairs as pictured in this video.
All opinions expressed by Michael Wesson and/or his guests are solely for entertainment purposes and shall not be interpreted as an official sponsorship of a product, brand, enterprise nor a judgement of quality and/or value of a product, brand, and/or enterprise.
Furthermore, Michael Wesson and/or Britannica Restorations are not responsible for the comments published by viewers of said video.
Salvaging a worn R380 casingAdjusting the steering box on the vehicleKKSEVENS Induction HeaterR380 rear coverGearbox stand Mark 1 Mark 2 is on the way!TDCi   Stripping the top end of the engine to find out why it cracked the blockA few tips on bolt management and restorationRemoving and fitting bearings LT230 Fitting input racesUnboxing the 2kw Aerolyn 2000 Air Heater ProLT77 aftermarket filter problems - watch out!Fixing Jims Ford Ranger heaterCan this neglected LT77 be restored?
Britannica Restorations Ltd |

Salvaging a worn R380 casing

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER