S124 v8 turbo last chassis mod.  finished crank case breather system @JMSpeedshop
S124 v8 turbo last chassis mod.  finished crank case breather system  @JMSpeedshop
Uploaded May 2023 | Updated November 2026, 4 days ago
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter

S124 v8 last chassis mod. finished crank case breather system

After a few very busy weeks i found a day  to finally  get some progress on the car.   I did the last modification to the chassis. And i finished the crank case breather system.

The center shaft or prop shaft center bearing needed some modifications to fit.   My center shaft is oem from W210 E420/E430.  This axle is factory fit to the 722.6 amg gearbox and the oem E420 rear diff im using .  The Oem center shaft bearing will not fit so i have mounted a oem e320 bearing this had also a 30mm inner diameter.

The center bearing shaft mouting point on the chassis needed to be moved 5-10cm more backwards. So this is removed from the oem location and welded back on the new spot.  Everything is coated again.  Axle is mounted and all connection torque down.  also the heat shield is back in place.

The crankcase breather needed a vacuum connecton to the intake this is done with a 22mm tubing.   The tubing is modified with a small venturi on the end that will improve the suction capacity.   This is mounted in front of the turbo after the intake filter.   This location will always have a vacuum, because the air filter will always have some sort of restriction.

Next will be the fuel system.  i wanted to start on it already.  but will do a full video on it.  this will be the next one.  I have already got the fuel pump and filter mounted together with all the connectors in place.  Everything to get the system mounted is in house only the flexible fuel lines need to be made when the lenght is know later on.

if there are any questions just ask

JMSpeedshop.com
S124 v8 turbo last chassis mod.  finished crank case breather systemM113 turbo.   Single Pulsar 7170G. Custom 4-1 headers    JMSpeedshop.com BuildAudi A8 W12 6.0 D2  Review & Testdrive JMSpeedshop.comMercedes 320CE convertible A124  very nice classicFIRST START The 6.0 V12 is Alive !!! the W201 V12 is running !!!S124 V8 Turbo street tuning up to 0,8barBest HP for money !!! Mercedes E55 AMG KompressorM113 engine rebuild - Part 11 - Turbo Crankshaft & New Rods + Piston installed.Mercedes V12 engine swap Update. JMSpeedshop.com online !!Mercedes SL560 R107  Perfect Summer daily !! review & testdriveThe V12 is on its wheels : W201-V12 Project JMSpeedshop.comJaguar XJR X308  Review & Testdrive JMSpeedshop !
JMSpeedshop ! |

S124 v8 turbo last chassis mod. finished crank case breather system

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER