Uploaded December 2017 | Updated November 2026, 11 hours ago
Put the 30 lb injectors in and it now sports the new #40 roller chain to drive the valves. This improves the timing accuracy and durability greatly. The valves and exhaust have all been ported as well with an approximate 50% increase in cross sectional area in each intake, exhaust and exhaust manifold.
Throttle response is the best it's ever been and very zippy. Once the intake gets re-installed, we will re-tune the fueling since it easily floods on start up and anything over 1/3 throttle it chokes.
The drive sprocket's collet based shaft clamp is slipping and was the cause of the engine to die at the end of this video.
Idle was 1800 rpm in this video. I hit a maximum of about 5500 rpm. It looks like a slightly stiffer tensioner spring will improve the chain vibration a bit.
The entire cooling system was redesigned to double the flow and to eliminate any non-circulating loops. About 25-30 man-hours went into re-routing all the tubes, the secondary water pump and getting it all connected together. There is no more space for tubes in the engine bay at this point...
Put the 30 lb injectors in and it now sports the new #40 roller chain to drive the valves. This improves the timing accuracy and durability greatly. The valves and exhaust have all been ported as well with an approximate 50% increase in cross sectional area in each intake, exhaust and exhaust manifold.
Throttle response is the best it's ever been and very zippy. Once the intake gets re-installed, we will re-tune the fueling since it easily floods on start up and anything over 1/3 throttle it chokes.
The drive sprocket's collet based shaft clamp is slipping and was the cause of the engine to die at the end of this video.
Idle was 1800 rpm in this video. I hit a maximum of about 5500 rpm. It looks like a slightly stiffer tensioner spring will improve the chain vibration a bit.
The entire cooling system was redesigned to double the flow and to eliminate any non-circulating loops. About 25-30 man-hours went into re-routing all the tubes, the secondary water pump and getting it all connected together. There is no more space for tubes in the engine bay at this point...










