Uploaded December 2023 | Updated November 2026, 3 days ago
This Rohde & Schwarz 100KHZ TO 1GHZ Radio Comms Tester has a defective variable RF level control. After verifying the fault we consult the service manual & begin to strip down the instrument & remove the front panel to allow access to the defective PCB. We also find that another fault i had noticed was that the Display backlight flickers quite bad every now & then this is due to a loose plug & socket connection to the High Voltage LCD Backlight inverter module, after noticing that we then remove the defective PCB containing the Variable control Hall Effect devices & setup an experimant to measure both hall sensors with the spin wheel 24 point magnetic wheel. Using a Rohde & Schwarz NGM02 PSU & Rigol oscilloscope we analyse the digital waveform & we see a major error with one hall sensor. Continuing our diagnosis we encounter iron filings & clean up the magnetic wheel which consists of 12 North & 12 South Pole magnets. After cleaning the wheel sensors its still faulty so we then replace the two hall devices from RS Components, with new & test again revealing the defect has been resolved. We then move onto the issue with the flickering display & try to disassemble the receptacles from the Inverter socket, although initially we manage to tighten the connection it was still not good enough so we removed both Plug & Socket & hard wired the cables together thus removing the troublesome plug & socket. We then re assemble the test set taking great care & check all connections before switch on. After which we soak test the instrument for several hours to confirm the defect is now repaired. The main defect diagnosis was failing Hall Effect Switches / Sensors.
This Rohde & Schwarz 100KHZ TO 1GHZ Radio Comms Tester has a defective variable RF level control. After verifying the fault we consult the service manual & begin to strip down the instrument & remove the front panel to allow access to the defective PCB. We also find that another fault i had noticed was that the Display backlight flickers quite bad every now & then this is due to a loose plug & socket connection to the High Voltage LCD Backlight inverter module, after noticing that we then remove the defective PCB containing the Variable control Hall Effect devices & setup an experimant to measure both hall sensors with the spin wheel 24 point magnetic wheel. Using a Rohde & Schwarz NGM02 PSU & Rigol oscilloscope we analyse the digital waveform & we see a major error with one hall sensor. Continuing our diagnosis we encounter iron filings & clean up the magnetic wheel which consists of 12 North & 12 South Pole magnets. After cleaning the wheel sensors its still faulty so we then replace the two hall devices from RS Components, with new & test again revealing the defect has been resolved. We then move onto the issue with the flickering display & try to disassemble the receptacles from the Inverter socket, although initially we manage to tighten the connection it was still not good enough so we removed both Plug & Socket & hard wired the cables together thus removing the troublesome plug & socket. We then re assemble the test set taking great care & check all connections before switch on. After which we soak test the instrument for several hours to confirm the defect is now repaired. The main defect diagnosis was failing Hall Effect Switches / Sensors.










