Richard Raffan on re-turning three roughed-out cylinders @RichardRaffanwoodturning

Richard Raffan | Richard Raffan on re-turning three roughed-out cylinders @RichardRaffanwoodturning | Uploaded April 2023 | Updated October 2024, 10 hours ago.
Lots of useful stuff in this video as I work around common problems. You see several ways of holding a cylinder on the lathe. You see similar cuts from different angles, a few recovery techniques for when things don't go as planned, and finally using a thread-chaser to create clumps of beads.

Richard Raffan turns Kauri Pine and shows a new undercutting tool.

Richard Raffan turns a vase in response to the third 4-Ways project.

Richard Raffan marking centre and laying out diameters on a wood lathe.

Richard Raffan turns a signature scoop in redgum

Richard Raffan making a loquat plate from a short board

Richard Raffan completes two part-turned salad bowls in real time.

Richard Raffan on turning skittles using a skew chisel

Richard Raffan cuts small logs and an old bedpost into woodturning blanks.

Richard Raffan turns a screw chuck spacer

Richard Raffan turns & ebonises a hollow form for 4-Ways Project No.6

Richard Raffan turns a cross-grain box in Manchurian pear