Reviving a bricked VESC using an ST-Link programmer @surfdado
Reviving a bricked VESC using an ST-Link programmer @surfdado
Uploaded June 2022 | Updated September 2026, 2 hours ago
You loaded bad firmware onto your VESC and now you can no longer connect to it? You'll need an ST-Link USB dongle and the STLink Utility as well as a .bin file for your particular VESC hardware.

STLink Utility:
st.com/en/development-tools/stsw-link004.html
IMPORTANT: You also need male Dupont pins for the LFOC side, sorry Floaty ;)
Reviving a bricked VESC using an ST-Link programmerHow NOT to build a FunwheelGosmilo X9 - First Test and ImpressionsOnewheels: Bigger isnt always better...OneWheel Motors Overheating? Torture TestVESC IMU Accelerometer Calibration - How ToVESC OneWheel Part 3 - Initial Firmware Setup (Motor Config)Floatwheel Repair Anti Spark HackVESC OneWheel Part 5: Fun Weekend 2 in San DiegoTrying out FloatHub on a new XRVMaking the Floatwheel ADV safer / Lights and Remote TiltOneWheel Plus - Can I VESC it?
surfdado |

Reviving a bricked VESC using an ST-Link programmer

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER