Uploaded May 2012 | Updated November 2026, 3 hours ago
RepRap Prusa Mendel 3D Printer test. First motor test.
My first power supply exploded so this is running on a massively under powered one. I'm not going to switch the "hot end" heater on for that reason.
Followed the software installation procedure. Didn't get a connection until I added the drivers for the USB interface chip thing.
Printer appears to be talking to the pc now. cool.
RepRap Prusa Mendel 3D Printer test. First motor test.
My first power supply exploded so this is running on a massively under powered one. I'm not going to switch the "hot end" heater on for that reason.
Followed the software installation procedure. Didn't get a connection until I added the drivers for the USB interface chip thing.
Printer appears to be talking to the pc now. cool.










