Uploaded February 2017 | Updated November 2026, 9 hours ago
Mission Updates: spaceflight101.com/dragon-spx10
It was over five years ago that the flames of an ascending rocket last graced a Kennedy Space Center Launch Pad when the Space Shuttle lifted off on its final voyage in 2011. Kennedy’s historic Launch Complex 39 returned to rocket launch operations on Sunday with a most impressive liftoff of SpaceX’s Falcon 9 rocket – ushering in a new era of commercial launch operations from the storied space center.
Falcon 9 lifted off from the southernmost of the two former Shuttle Pads at 14:39 UTC on Sunday, taking to the skies over a cloudy Space Coast to lift the tenth operational Dragon spacecraft into orbit for a critical supply delivery to the International Space Station. The 65-meter tall rocket swung to a north-easterly departure path and fired its first stage for the first two minutes and 21 seconds before the single-engine second stage took over for a nearly seven-minute burn to loft the Dragon into orbit.
Mission Updates: spaceflight101.com/dragon-spx10
It was over five years ago that the flames of an ascending rocket last graced a Kennedy Space Center Launch Pad when the Space Shuttle lifted off on its final voyage in 2011. Kennedy’s historic Launch Complex 39 returned to rocket launch operations on Sunday with a most impressive liftoff of SpaceX’s Falcon 9 rocket – ushering in a new era of commercial launch operations from the storied space center.
Falcon 9 lifted off from the southernmost of the two former Shuttle Pads at 14:39 UTC on Sunday, taking to the skies over a cloudy Space Coast to lift the tenth operational Dragon spacecraft into orbit for a critical supply delivery to the International Space Station. The 65-meter tall rocket swung to a north-easterly departure path and fired its first stage for the first two minutes and 21 seconds before the single-engine second stage took over for a nearly seven-minute burn to loft the Dragon into orbit.



![[Timelapse] Dragon SpX-10 Robotics Part 2 (SAGE-III Installation)
Timelapse video of robotic activities underway outside the International Space Station from March 2 through 8 covering the installation of the Stratospheric Aerosol and Gas Experiment III (SAGE-III) and the removal of the Robotic Refueling Mission payloads. This clip plays at 50x real speed, you can use YouTubes speed adjustment function to slow it down or increase to up to 100x real speed.
SAGE-III is taking a permanent position on Express Logistics Carrier 4 out on the starboard truss of the Space Station from where it will monitor ozone and aerosols in Earths atmosphere to continue a long-term data record going back into the 1980s when SAGE instruments provided pivotal data enabling an accurate calculation of ozone loss in the atmosphere that prompted major policy changes to protect Earth’s ozone layer.
Major Steps seen in this video:
1) Removal of the SAGE Instrument Payload from the Dragon SpX-10 Trunk Section, March 2 - 23:13 UTC
2) Removal of the SAGE Nadir Viewing Platform from the Dragon Trunk, March 3 - 15:47 UTC
3) Installation of the OPALS Payload in the Dragon Trunk for Disposal, March 3 - 22:22 UTC
4) Removal of the Robotic Refueling Mission pallet from ELC-4, March 5 - 22:08 UTC
5) Installation of the SAGE Nadir Viewing Platform on ELC-4 FRAM-3, March 6 - 0:39 UTC
6) Installation of the SAGE Instrument Payload to the Nadir Viewing Platform, March 7 - 23:36 UTC
(All times approximate!)
Dragon SpX-10 delivered three external payload components - SAGE-III NVP and IP (seen in this video) and the Space Test Program - Houston 5 payload (its installation is covered here: https://youtu.be/stQvMaz-5gY) Open robotics tasks include the installation of the Robotic Refueling Mission and a MISSE Flight Support Equipment component in the Dragon Trunk for disposal.
More about SAGE-III: http://bit.ly/2luKv65
More about the Robotic Refueling Mission: http://bit.ly/2m7HXb2
More about OPALS: http://bit.ly/2m52QTB [Timelapse] Dragon SpX-10 Robotics Part 2 (SAGE-III Installation)](https://i.ytimg.com/vi/cSBlGYQN300/mqdefault.jpg)






