Uploaded March 2026 | Updated November 2026, 3 hours ago
We take a look at the RAA2P3226 Inductive Position Sensor Evaluation Kit from Renesas, enabling magnet-free, contactless position sensing for a wide range of industrial applications.
Inside the box, you’ll find three sensor modules, a programming board with two 10-wire sensor cables to connect to the sensor modules, and a USB cable.
In this demo we’re going to connect two of the sensor modules to the programming board and use the evaluation software to monitor the output of each.
Connect two of the sensor modules to the programming board using the 10-wire cables. Notice that the sensor modules have one PCB that rotates over another. This magnet-free setup enables simple, reliable, and low-cost implementation.
Now connect the programming board to your PC using the USB cable and open the evaluation software.
Create a new project for the RAAP3226. You may be prompted to update the firmware on your programming board, but otherwise you can start evaluating right away. I prefer the plot view and I’ll hide the extra plots for now, then start reading. As we rotate the knob on the sensor module, you can see the output changing accordingly. You can also click Device 1 at the bottom of the screen and then switch to Device 2 to repeat the evaluation. In this case, you’ll notice the output resets earlier, because the first sensor I used was a 19-bit sensor and this is an 18-bit sensor. This allows you to easily compare the performance of the different sensor modules in your application.
digikey.com/en/products/detail/renesas-electronics-corporation/RTKA2P3226S00000BE/27574647
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey
We take a look at the RAA2P3226 Inductive Position Sensor Evaluation Kit from Renesas, enabling magnet-free, contactless position sensing for a wide range of industrial applications.
Inside the box, you’ll find three sensor modules, a programming board with two 10-wire sensor cables to connect to the sensor modules, and a USB cable.
In this demo we’re going to connect two of the sensor modules to the programming board and use the evaluation software to monitor the output of each.
Connect two of the sensor modules to the programming board using the 10-wire cables. Notice that the sensor modules have one PCB that rotates over another. This magnet-free setup enables simple, reliable, and low-cost implementation.
Now connect the programming board to your PC using the USB cable and open the evaluation software.
Create a new project for the RAAP3226. You may be prompted to update the firmware on your programming board, but otherwise you can start evaluating right away. I prefer the plot view and I’ll hide the extra plots for now, then start reading. As we rotate the knob on the sensor module, you can see the output changing accordingly. You can also click Device 1 at the bottom of the screen and then switch to Device 2 to repeat the evaluation. In this case, you’ll notice the output resets earlier, because the first sensor I used was a 19-bit sensor and this is an 18-bit sensor. This allows you to easily compare the performance of the different sensor modules in your application.
digikey.com/en/products/detail/renesas-electronics-corporation/RTKA2P3226S00000BE/27574647
Maker.io - digikey.com/en/maker
DigiKey’s Blog – TheCircuit digikey.com/en/blog
Connect with DigiKey on Facebook facebook.com/digikey.electronics
And follow us on X https://x.com/digikey










