RC Era C189 ESC Board Testing Using a Servo Tester @MarioIArguello
RC Era C189 ESC Board Testing Using a Servo Tester  @MarioIArguello
Uploaded August 2026 | Updated September 2026, 3 weeks ago
This is a detailed video on how to test the RC Era C189 ESC board to make sure it is getting proper voltage and signal to the motors. This test requires a Servo Tester and a simple wiring harness made from a servo lead, a couple micro pin male headers and a small on/off switch.
RC Era C189 ESC Board Testing Using a Servo TesterRare Hot Wheels Light Speedster Solar Flash on MIA Track 28 Years Later Original Charge CapacitorYerf Dog Restoration Tip - Splitting 5 Thick Foam in Half with Broken Bandsaw BladeMIA Capacitor Powered Car 1:64 Scale - 4 Plus Minute Run  0ver 125 Laps! On a Single Charge!Mattel Hot Wheels 1:64 X-V Racers  On MIA 3D Printed Small Oval TrackRC Era C189 - MIA Rotor Blades and Head Damping Tuning Kit, MIA TUFF™️LG and Tail Guard, TX UogradesA great way to monitor Amps Voltage  of an Electric Cycle Kart Go KartSatanic Logo 😂1970 $17.40 Multimeter Old school1/2 Scale Pilot Figure for 1/2 Scale MIA Quicksilver Style RC Ultralight2025 New MIA Airplane Set of PartsAnother Experimental Surface for Turbo Racing TrackMIA Cycle Kart Project - 1:4 Scale  Spoke Wheel
MIA Micro-FLIGHT (Mario I. Arguello) |

RC Era C189 ESC Board Testing Using a Servo Tester

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER