Uploaded March 2015 | Updated September 2026, 1 week ago
Warning: Video is terrible quality.
Visual process of updating the S100 Windows CE 6.0 Factory Look Aftermarket Navigation / Entertainment System for 2013-2014 F150 Ford Truck. Most likely the same process for any 'S100' Device. This particular update addresses some bugs in the apps and radio.
Instructions (You must read disclaimer before proceeding!)
*As with anything I post, DO THIS AT YOUR OWN RISK. If done incorrectly, there is a potential of 'Bricking' your device. I will accept no responsibility for anything which may go wrong or unexpected. Verifying software and procedures / researching proper instructions is 100% your responsibility.
Following these instructions below, binds you to the disclaimer above *
Locate update files. roadnav.com is a good site.
Unzip them onto a blank micro SD card (at least 4gb but no larger than 16gb)
With the key on, reset S100 to factory defaults.
Leaving the key on, turn the S100 completely off.
Insert the now loaded SD card into the 'Map' slot (remove map SD)
Turn S100 unit on. (This is where the video begins)
Program Update will self install.
As you can see in the video, there's a few times it beeps and hesitates and seems to stall DO NOT TOUCH ANYTHING... let it finish!
Once it finishes, it will say so at the bottom. Remove the SD card, system should restart once the SD card is removed.
Don't forget to add map SD card back in. Also, you might need to update the navigation / map path in the settings.
Warning: Video is terrible quality.
Visual process of updating the S100 Windows CE 6.0 Factory Look Aftermarket Navigation / Entertainment System for 2013-2014 F150 Ford Truck. Most likely the same process for any 'S100' Device. This particular update addresses some bugs in the apps and radio.
Instructions (You must read disclaimer before proceeding!)
*As with anything I post, DO THIS AT YOUR OWN RISK. If done incorrectly, there is a potential of 'Bricking' your device. I will accept no responsibility for anything which may go wrong or unexpected. Verifying software and procedures / researching proper instructions is 100% your responsibility.
Following these instructions below, binds you to the disclaimer above *
Locate update files. roadnav.com is a good site.
Unzip them onto a blank micro SD card (at least 4gb but no larger than 16gb)
With the key on, reset S100 to factory defaults.
Leaving the key on, turn the S100 completely off.
Insert the now loaded SD card into the 'Map' slot (remove map SD)
Turn S100 unit on. (This is where the video begins)
Program Update will self install.
As you can see in the video, there's a few times it beeps and hesitates and seems to stall DO NOT TOUCH ANYTHING... let it finish!
Once it finishes, it will say so at the bottom. Remove the SD card, system should restart once the SD card is removed.
Don't forget to add map SD card back in. Also, you might need to update the navigation / map path in the settings.
