Uploaded January 2024 | Updated September 2026, 2 weeks ago
I decided to blank off one inlet to allow the speed to be reduced and therefore the noise level as well during day to day use.
I now turn the unit on and off at a convenient socket by the bench.
The idea is to run another pipe over the ceiling and use with the marking laser as and when required.
Thanks to Andy on my forum posting instructions I have managed to tighten up the slightly loose tube and improve the very loose tube.
I was surprised how well cold and damp TPU printed.
The kiln now has a chimmney with a glass fibre pad and activated charcoal.
Hopefully combining everything will keep the fumes at bay.
I decided to blank off one inlet to allow the speed to be reduced and therefore the noise level as well during day to day use.
I now turn the unit on and off at a convenient socket by the bench.
The idea is to run another pipe over the ceiling and use with the marking laser as and when required.
Thanks to Andy on my forum posting instructions I have managed to tighten up the slightly loose tube and improve the very loose tube.
I was surprised how well cold and damp TPU printed.
The kiln now has a chimmney with a glass fibre pad and activated charcoal.
Hopefully combining everything will keep the fumes at bay.
