Uploaded August 2026 | Updated November 2026, 14 hours ago
Cutting cheap lauan plywood on the CNC is the worst for tear out. No matter the bit, chip out is inevitable. Try putting tape down first to save the edges. Just skip the CA glue hold down method since this brittle wood will snap when you try to pull it up.
#cnccutting #woodworkingtips #cncmachining #plywoodprojects #idcwoodcraft #shorts
Cutting cheap lauan plywood on the CNC is the worst for tear out. No matter the bit, chip out is inevitable. Try putting tape down first to save the edges. Just skip the CA glue hold down method since this brittle wood will snap when you try to pull it up.
#cnccutting #woodworkingtips #cncmachining #plywoodprojects #idcwoodcraft #shorts










