My 6040 CNC | Pumotix Install from Mach3 @rickcperry | Uploaded October 2021 | Updated October 2024, 15 hours ago.
Video #2 showing the speed increase! - youtu.be/Ee01X_kTzDY
Installing and trying out a new software to replace my outdated Mach3 software. This will allow me to use a 64 bit computer and Windows 10 instead of Windows XP.
Hopefully this is one of a few videos on this new Ethernet based motion controller.
NOTE: Sorry about video quality, Didn't realize the camera setting until after all footage was shot.